The transfer case adaptor housing replaces the automatic transmission extension housing. The adaptor housing then fits to the transfer case using the original Nissan bolts. The housing has mounting provision for the hi/low lever.
The automatic transmission will need to be disassembled. The main output shaft is removed and replaced with one supplied in the adaptor kit.
The output shaft in the kit is supplied on an exchange basis. If your shaft is not supplied with the original order a deposit of $110 will be charged. Change over shafts that are pitted, rusted or heat damaged will not be accepted. The deposit will be refunded when a suitable shaft is received at our factory. Postage or freight is the responsibility of the sender.
- Two adaptor housing
- Change over main output shaft
- Reluctor ring
- Adaptor reluctor ring
Note: Please check your transfer case input spline, to suit this kit it must be 30 spline.