Bell Housing Adaptor Kit – Chev V8 Petrol (early) 168 Tooth Flywheel to LandCruiser FJ (Auto)

Bell Housing Adaptor Kit to suit Chev V8 Petrol (early) 168 Tooth Flywheel to Toyota LandCruiser FJ (Auto)

Chev V8 with a 168T flywheel to FJ60, FJ62 & FJ80 4 Speed Auto Kit part no. MFK560C168A utilises the GM flywheel, Toyota flex plate and torque converter. Instead of a new bell housing, a flywheel housing is supplied which measures 122 mm/4.8″ long. This housing has the GM bolt pattern on the front and the Toyota 1F, 2F, and 3F, bolt pattern on the rear.

The kit has been designed to allow for firewall clearance without shifting the transmission or altering the drive shaft lengths.

The transmission torque converter is coupled to the flywheel via a crankshaft adaptor. The adaptor has the Toyota crankshaft bolt pattern and spigot diameter on the transmission end, with the GM crankshaft bolt pattern and spigot diameter on the engine end. This allows the Toyota flex plate and torque converter to be bolted to the rear as with the old 3F engine. On the rear of the engine, a manual flywheel is used instead of a flex plate, as there is no provision to support a flex plate when the starter motor is engaged.

Kit Includes

• Adaptor flywheel housing
• Crankshaft adaptor boss
• Adaptor cover plate
• Oil pressure sender adaptor
• Water temp sender adaptor
• Bolts
• Washers
• Downloadable Instructions

To Suit

• Toyota LandCruiser FJ 3F – 4.0L 4-speed auto