Hall effect (3 wire) speed sensor interface to suit cable driven speedometers
The speed sensor is screwed into the transfer case in place of the speedometer cable, which screws into the back of the new sensor. The signal from the sensor is sent to an interface box, which then processes the signal prior to sending it on to the ECM. The speed sensor comes with the sender, an interface box, with an interconnecting loom, which has a waterproof plug located near the sender. A small loom is also provided to allow the interface box to be connected to the ECM, ignition B+ and earth.
NOTE: Will only suit the following engines VN, VP, VR and VS manual engines including VN and VP automatic engines
- Hall effect vehicle speed sensor unit
- Cable drive sensor pickup
- Installation hardware