Upgrade your GQ Patrol to the more advanced wheel bearing locking nut system as included standard on the GU Patrol.
When changing or adjusting wheel bearings, jack the vehicle off the ground, remove the hub & nut assembly. Replace or repack the bearings, place the tab washer in, then thread the large hub nut on the stub. If you have installed new bearings, rotate the wheel when tightening – use your manual to get the right torque settings to apply to the nut.
Put the locking washer into position, then install the two small screws. Always check & test for play after a couple of hundred kms.
We have included the hub tool in the kit to make it easy to screw everything back up! You can complete the conversion with just this kit, and a few tools from the shed.
The Hub Nut/Socket tool is designed for use with a ½” drive, so you can use your standard socket set so tighten or remove the wheel bearings.To suit:
- Nissan Patrol GQ - all models
- Ford Maverick
- 1 x GU Hub Nut/Socket tool
- 2 x Inner Hub washer (S0506R)
- 2 x Outer Hub Washer (S0510R)
- 2 x Bearing locking Wash (S0511R)
Part No: NISCHWS