Speed Sensor

MFK1470H, INDUCTIVE and HALL EFFECT

VEHICLE SPEED SENSOR

EFI engines previously fitted with 4L60E transmissions, that are now fitted to manual transmissions will require this VSS.

This VSS is designed to feed an inductive signal to the Commodore PCM and a Hall Effect signal to the Vehicle Speedometer.

When fitting this VSS to a Hilux, 4/Runner or Surf transfer case you will need to purchase a genuine speedometer cable drive to replace the original electronic version.

For the Commodore PCM to function properly it must acquire information from external sensors. One vital input is obtained from the original Vehicle Speed Sender (VSS).

The VSS provides an indication of road speed to the PCM. The sender is an inductive type, which sends pulses directly to the PCM.

If the PCM receives no pulses from the VSS input, a fault Code will be set in the PCM. This will result in increased fuel consumption, poor idle quality or stalling can be experienced. Vehicles fitted with 4L60E automatic transmissions have the Commodore 24mm VSS fitted in the adaptor housing.

The VSS is vital for correct operation of the following functions:

  • The PCM will shut off the fuel during deceleration. The VSS must be operating correctly for this to occur.
  • The PCM has an in-built memory, it learns the correct amount of fuel to deliver under certain conditions. The VSS plays a vital role in determining when these conditions occur.

The Hall Effect VSS outputs four pulses per revolution as per the original Toyota VSS. If you have fitted larger tyres or changed the diff ratios a Ratio Match Box should be fitted to correctly calibrate the speedometer.

 
4L60E Automatic

In a V6/V8 4L60E 4WD transfer case conversion the VSS must monitor the automatic transmission main output shaft for correct transmission operation. For this reason this VSS cannot be used with a 4L60E.

 
Extension Piece

Some VSS units will not fit directly to transfer cases such as the Land Cruiser 40 Series which is fitted with a transmission brake. To move the VSS unit, to position it where it will clear the transmission brake and or the transfer case an extension piece is required. Marks 4WD have manufactured such a unit which is now a stock item. The unit moves the VSS 85mm away from the speedometer cable drive.

 
  • Extension piece 85mm long.
  PART NO. MFK1470EXT

The Kit consists of: 85mm long extension.

Home Up

Copyright © 2006 Marks 4WD Adaptors                                     CONTACT US BY EMAIL                                     Last modified: July 30, 2008