The MFK680/CK engine mounting kit to suit the 80 series Land Cruiser consists of replacement chassis brackets, engine mounting rubbers and bolts. The original Toyota chassis brackets are welded to the chassis and must be cut off with a grinder to make room for the new brackets. The new brackets must also be welded to the chassis, if you're not a good or qualified welder, we suggest a contract welder do the job. When using this kit firewall modification is required.

Alternatively we now manufacture engine mounting brackets that bolt directly to the Chevy engine block and onto the original Toyota engine mounting rubbers.

Drive Shaft Spacer

To prevent the need to modify the firewall  behind the right hand cylinder head we suggest slotting the cross member mounting holes to bring the engine forward approximately 20mm. After this is done the rear drive shaft will need to be lengthened or alternately a spacer can be fitted between the transfer case output flange and the drive shaft. Marks 4WD Adaptors now manufacture a 20mm long spacer, see part number below.

When fitting the 6.2 or 6.5 ltr diesel with this conversion kit the GM engine accessories may be used, for example the A/C compressor, power steering pump and alternator. Note: The original GM water pump with a single serpentine belt is a reverse direction pump. Alternatively the Toyota accessories could be adapted to fit the new engine.

Air Cleaner Adaptor

Chevy diesel engines are usually fitted with an air cleaner that looks similar to the type fitted to Chevy petrol carburettor engines. This type of air cleaner will require modifications to allow it to be used with a snorkel. To over come this problem Marks 4WD Adaptors now manufacture a cast aluminium hat that takes the place of the GM air cleaner. The inlet takes a 3 1/2" hose and will fit directly to a late model Toyota air cleaner hose, should you have an early model air cleaner with a 3" outlet a rubber adaptor hose can be used. These parts can be purchased separately or as a complete kit.