My Cart:

0 item(s) - $0.00
You have no items in your shopping cart.

bool(true) index---index
Chev V8 168T early to Landcruiser 4.2L 4-speed auto

Chev V8 168T early to Landcruiser 4.2L 4-speed auto

Part Number: MFK1060C168A

Availability: In stock

Quick Overview

Toyota Landcruiser engine conversion using Chev V8 early (pre 1986) - 168T FLYWHEEL

To suit:

  • 4.2L 1HDT 4-speed automatic


Bell Housing Adaptor Kit

The flywheel housing is supplied which measures 61 mm/2.4" long. This housing has the GM bolt pattern on the front and the Toyota 1HZ, bolt pattern on the rear.

The transmission torque converter is coupled to the flywheel via a crankshaft adaptor. The adaptor has the Toyota bolt pattern and spigot diameter on the transmission end with the GM crankshaft bolt pattern and spigot diameter on the engine end. This allows the Toyota flex plate and the Toyota torque converter to be bolted to the rear as with the old 1HZ engine.

On the front of the crankshaft adaptor a manual flywheel is used instead of a flex plate, as there is no provision to support a flex plate when the starter motor is engaged.

When ordering a Chev kit you must make sure that the GM starter motor you intend using is the correct type. Chev V8 engines were released with two flywheel and flex plate sizes; they where fitted with a 153-tooth ring gear or 168-tooth ring gear, as a result two starter motor offsets are available.

The kit will only suit the 168-tooth ring gear.

It will also be necessary to identify the year of the engine, after 1986 the engine crankshaft bolt pattern changed. The bolt pattern is smaller as is the spigot, which locates the flywheel on the crankshaft (52.4-mm). The post 1986 Chevy small block engines are also externally balanced. One way to identify a late model Chevy engine is by the one-piece external, rear main oil seal.

NOTE 1: This kit will only suit the early (pre 1986) Chev V8 fitted with a 168-tooth flywheel.

NOTE 2: The factory automatic transmission will require a stand-alone computer to control shifting of the transmission once the original engine and ECU is removed.

NOTE 3: You will need to reuse the original 168T GM manual flywheel from your engine.

Kit contains:

  • Flywheel housing
  • Crank adapor
  • Dowels
  • Flywheel cover plate
  • Spigot bearing
  • Oil pressure sender adaptor
  • Water temperature sender adaptor
  • Bolts
  • Washers
  • Instructions

Ask for more information about this product

* Required Fields