Mitsubishi Gen 3 – Low Range Gears 66% (3.15:1) Reduction – Manual

AUD$1,595.00 (Excl. Tax AUD$1,450.00)

Mitsubishi low range gears – ratio 3.15:1 – manual gearbox

To suit:

Generation 3 transfer case – 27 tooth (spline) input gear

  • Montero
  • Pajero
  • Shogun
Brands: Marks 4WD
View cart


Marks 4WD Adaptors manufacture low range reduction gears to suit many models of Mitsubishi Pajero, Montero and Shogun. These gears are manufactured in house at our facility in Melbourne, Australia. We manufacture two reduction ratios for the Generation 3 transfer cases to suit different vehicle applications and requirements.

The 66% reduction gears give you a great overall reduction and suit vehicles fitted with a manual transmission. These are mainly suited vehicles used for rock crawling, sand, desert or vehicles that are prone to run away down hill. As an example this reduction gives a manual vehicle about one and a half gears below where the factory gearing sat. High range is not altered when fitting our low range gears.

To calculate your vehicle’s ratio, click here.


Will these gears fit my vehicle?

You will need to remove and open the transfer case and check the idler gear has external shoulders for the roller bearings and the face width of the gear must be approximately 25mm and 20mm respectively. Please see image below for reference;

Mitsubishi Pajero Gen 3 Low Range Gear Measurements



  • A Mitsubishi workshop manual is required for fitment
  • The input gear spline is 27T – 29.6mm diameter

Kit contains:

  • Input gear
  • Idler gear
  • Output gear
  • Roller bearing
  • Seals

To suit:

Generation 3 transfer case – 27 tooth (spline) input gear

  • Montero
  • Pajero
  • Shogun

Part No. PAJ-GEN3-3.15M

    Contact Us


    There are no reviews yet.

    Only logged in customers who have purchased this product may leave a review.