Transfer Case Adaptor – TH700 to LandCruiser 80, 100 Series Auto (HF2A Case)

Transfer Case Adaptor to suit TH700 to Toyota LandCruiser 80, 100 Series Auto (HF2A Case)

The kit is designed to use a GM transmission from a 2WD vehicle. The 4WD version has a short output shaft and can not be used unless you replace the output shaft with one from a 2WD version.

The overall length of the GM transmission and the adaptor is the same as the original LandCruiser 4-speed auto gearbox when fitted with either of our MFK1060, MFK1045 or MFK1260 Chevy V8 to manual transmission kits.

The automatic transmission main output shaft drives the transfer case through the new transfer case, input shaft supplied in the kit. The transfer case will need to be disassembled to fit the new input shaft supplied in the kit. The automatic transmission main output shaft is retained therefore, the transmission will not require disassembly. However the shaft will need to be cut down to fit into the new transfer case input shaft.

The hi-low 4WD-lever housing is simply bolted to the top of the new adaptor housing and emerges through the original hole in the transmission tunnel.

NOTES

•  The 4L60E automatic transmission oil pan will require modification to clear the front tail shaft on all 80 & 100 Series LandCruiser’s
• The 700R4 and 4L60E has an overall case length of 594 mm/23.4″. The 4L60E six bolt has an overall case length of 553 mm/21.8″.

Kit Includes

• Adaptor housing
• Transfer case input shaft
• Seal
• Bolts
• Downloadable Instructions

To Suit – Toyota LandCruiser

• 80 & 100 series
• Full time 4wd auto transmission HF2A transfer case

Notes

• The new transfer case input shaft supplied in the kit does not have a spline for PTO option.
• The adaptor housing is machined to accept the 80/100 series HF2A transmission mounting rubber.
• The TH700 automatic transmission oil pan will require modification to clear the front tail shaft on all 80 & 100 Series LandCruiser’s