Mitsubishi Gen1 Low Range Gears 48% - 2.85:1 Reduction - Manual
Mitsubishi low range gears - ratio 2.85:1 - manual gearbox
Generation 1 transfer case - 24 tooth (spline) input gear
Marks 4WD Adaptors manufacture low range reduction gears to suit many models of Mitsubishi Pajero, Montero and Shogun. These gears are manufactured in house at our facility in Melbourne, Australia. We manufacture the 48% reduction gears for the Generation 1 transfer cases.
The 48% reduction gears give you a great overall reduction and suits vehicles fitted with manual or automatic transmissions. These are suited to vehicles used for rock crawling, sand, desert, etc. or vehicles that are prone to run away down hill (fitted with an automatic transmission). As an example this reduction gives a manual vehicle about one gear below where the factory gearing sat. High range is not altered when fitting our low range gears.
Will these gears fit my vehicle?
You will need to remove and open the transfer case and check that the gear has a bore through the centre. Please see image below for reference;
- A Mitsubishi workshop manual is required for fitment
- The input gear spline is 24T - 26.5mm diameter
- Input gear
- Idler gear
- Output gear
- Roller bearing
To suit Generation 1 transfer case - 24 tooth (spline) input gear
Part No. PAJ-2.85M