Low Range Gears 66% (3.15:1) Reduction (Auto) to suit Mitsubishi Gen 3
Marks 4WD Adaptors manufacture low range reduction gears to suit many models of the Mitsubishi Pajero, Montero, Shogun, Triton, Delica, L200 and L300. These gears are manufactured in-house at our facility in Melbourne, Australia. We manufacture two reduction ratios for the Generation 3 transfer cases to suit different vehicle applications and requirements.
The 66% reduction gears give you the biggest reduction we offer and suit vehicles fitted with an automatic transmission. These are mainly suited to rock-crawling vehicles or vehicles that are prone to run away downhill. For example, this reduction gives a manual vehicle about one and a half gears below where the factory gearing sat. High range is not altered when fitting our low-range gears.
Will these Gears fit my Vehicle?
You will need to remove and open the transfer case and check the idler gear has external shoulders for the roller bearings and that the face width of the gear must be approximately 25mm and 20mm, respectively. Please see the image below for reference;
Mitsubishi Pajero Gen 3 Low Range Gear Measurements
- 100% Australian Made
- Designed & Manufactured in-house at Marks4wd
- Input gear
- Idler gear
- Output gear
- Backlash eliminator
- Downloadable Instructions (requires login)
To Suit – Mitsubishi
- Generation 3 transfer case – 23 tooth (spline) input gear
- A Mitsubishi workshop manual is required for fitment
- The input gear spline is 23T