Bell Housing Adaptor Kit – Chev V8 Petrol (late) 168 Tooth Flywheel to LandCruiser 4.2L (5-speed manual)
AUD$1,350.00 (Excl. Tax AUD$1,227.27)
Toyota Landcruiser engine conversion using Chev V8 late (post 1986) – 168T flywheel
- 4.2L 1HDT 5-speed manual
- Ask a Question
- Reviews (0)
Bell Housing Adaptor Kit
This kit comprises of a flywheel housing running a cast iron flywheel.
The flywheel housing is supplied which measures 61 mm/2.4″ long. This housing has the GM bolt pattern on the front and the Toyota 1HDT, bolt pattern on the rear.
The new flywheel supplied in the kit accepts the original Toyota 12″ clutch. The flywheel is offset to the rear to place the clutch in its original position. The flywheel has no ring gear and must be used with the original GM flex plate and ring gear. Spacers and bolts are supplied to fix the flex plate to the back of the flywheel.
When ordering a Chevy kit you must make sure that the GM starter motor you intend using is the correct type.
The kit will only suit the 168-tooth ring gear.
It will also be necessary to identify the year of the engine, after 1986 the engine crankshaft bolt pattern changed. The bolt pattern is smaller as is the spigot, which locates the flywheel on the crankshaft (52.4-mm). The post 1986 Chevy small block engines are also externally balanced. One way to identify a late model Chevy engine is by the one-piece external, rear main oil seal.
NOTE 1: This kit will only suit the late post 1986 Chev V8
NOTE 2: You will need to reuse the original 168T GM auto flex plate from your engine.
- Flywheel housing
- Cast iron flywheel
- Flywheel cover plate
- Spigot bearing
- Oil pressure sender adaptor
- Water temperature sender adaptor
Only logged in customers who have purchased this product may leave a review.