-
Fan Shroud & Hose Kit - LS Series V8 to Patrol GU (RD28 / ZD30)
AUD $1,059.09AUD $1,059.09 (ex. tax)× -
Gear Select Module Install Kit - to suit GM without PRNDL and 6L80
AUD $86.36AUD $86.36 (ex. tax)× -
Navara D40 Ø 320mm - Delios Slotted Front Brake Rotors (1 x Pair)
AUD $290.91AUD $290.91 (ex. tax)× -
Bell Housing Adaptor Kit - Chev V8 Petrol - 153 Tooth Flywheel to LandCruiser FJ (Auto)
AUD $3,104.55AUD $3,104.55 (ex. tax)× -
DB1200 - G4O 4WD Brake Pads – Toyota LandCruiser 70, 80, 100 Series (Rear Pads)
AUD $190.91AUD $190.91 (ex. tax)× -
5th Gear Overdrive Ratio Change - LandCruiser HZJ, Hilux Series (from 0.838 to 0.711)
AUD $572.73AUD $1,145.45 (ex. tax)× -
Bell Housing Adaptor Kit - Holden V8 (Trimatic Pattern) to Hilux Gearbox (R150F, R151F 5-speed manual)
AUD $1,813.64AUD $1,813.64 (ex. tax)× -
Transfer Case Adaptor - 4L60E to LandCruiser 80, 100 Series Auto (HF2A Case)
AUD $2,086.36AUD $4,172.73 (ex. tax)× -
Sump - LS Series V8 Sump & Pickup - Patrol, LandCruiser, Hilux (Modified)
AUD $759.09AUD $1,518.18 (ex. tax)× -
Bell Housing Adaptor Kit - Chev V8 Petrol (early) 168 Tooth Flywheel to LandCruiser 4.5L Gearbox (5-speed manual)
AUD $3,445.45AUD $3,445.45 (ex. tax)× -
DB1365 - G4O 4WD Brake Pads – Toyota LandCruiser 70, 100 Series (Front Pads)
AUD $190.91AUD $190.91 (ex. tax)× -
Bell Housing Adaptor Kit - Chev V8 Petrol (early) - 168 Tooth Flywheel to LandCruiser 60, 70 Series (Manual)
AUD $3,818.18AUD $3,818.18 (ex. tax)× -
Dual Alternator Kit - 12v (LHS) / 24v (RHS) High Mount - LS V8 6.0L, 6.2L (VE-VF)
AUD $904.55AUD $904.55 (ex. tax)× -
Swivel Housing Overhaul Kit & Wheel Bearings - LandCruiser 76 ,78, 79 (Non-ABS), 80, 105 Series
AUD $340.91AUD $340.91 (ex. tax)× -
Radiator & Heater Hose Kit - LS Series V8 to Patrol GU (RD28 / ZD30)
AUD $177.27AUD $177.27 (ex. tax)× -
Accessory Mount Kit - Alternator (RHS) High Mount & A/C Compressor (LHS) Low Mount - LS V8 6.0L, 6.2L (VE-VF)
AUD $540.91AUD $540.91 (ex. tax)× -
Nissan Patrol GQ / GU - Low Range Gear Set - 24% (2.484:1) Reduction
AUD $1,813.64AUD $1,813.64 (ex. tax)× -
Bell Housing Adaptor Kit - Chev V8 Petrol to Land Rover / Range Rover (4 / 5-speed manual)
AUD $1,500.00AUD $1,500.00 (ex. tax)×
Speedo Corrector – LandCruiser / Hilux / Nissan Patrol
AUD $220.00 (Excl. Tax AUD $200.00)
To Suit
- Toyota LandCruiser – 70 series – VDJ76, VDJ78 & VDJ79 (does not suit 08/2016 on DPF models)
- Toyota Hilux – KUN, GGN
- Nissan Patrol – GQ / Y60, GU / Y61
Dakota Digital Electronic Speedo Corrector to suit Toyota LandCruiser, Hilux and Nissan Patrol.
This kit includes specific instructions to suit the VDJ70 and Hilux KUN/GGN vehicles.
Dakota’s electronic speedo corrector MFK1000 uses the SGI-100BT Universal Signal Interface Unit & can handle nearly all of your electric speedometer signal conversion and calibration issues. The SGI-100BT can recalibrate a 2,000 pulse per mile (ppm) through 250,000 ppm electronic speedometer pulse rates, either up or down. The SGI-100BT is great for adjusting aftermarket and OEM electric speedometers on vehicles after changing rear-end gears, tire sizes, or drive train changes affecting the speedometer.
The SGI-100BT is used as either a signal multiplier or signal divider (25%-400%), making this unit extremely flexible for almost any application.
While the SGI-100BT is intended to correct only the signal feeding the electronic speedometer, in many cases where a speed signal is shared or on a databus, the SGI-100BT can instead correct the signal feeding the engine and transmission computers.
For even greater flexibility, the SGI-100BT allows multiplication up to 16x, taking an 8,000ppm signal and converting to a 128,000ppm output, and includes a regulated 5V sensor output, allowing the use of the Dakota Digital SEN-01-5 speed sensor. A built-in LED display and push-button switches simplify set-up and calibration.
Note: If your vehicle is equipped with an anti-lock braking system (ABS), it is advised to ensure the signal reaching the ABS controller is not altered to eliminate any potential problems affecting control algorithms.
Some vehicles also utilize the output shaft speed to calculate transmission slip and lock-up. When a signal feeding the PCM is altered, this may cause the PCM to detect a constant slip. Consulting a service manual may assist in determining the signal routing within the vehicle if the SGI-5 is decided to be used in a situation such as this.
The unit measures 4″ x 2″ x 1″ and is designed to be mounted inside a vehicle.
Kit Includes
- 1 x SGI-100BT
- 4m Connection Cable
- Downloadable Instructions (require login)
- Note – We provide specific instructions for the LandCruiser VDJ70 and Hilux KUN/GGN vehicles.
To Suit
- Toyota LandCruiser – 70 series – VDJ76, VDJ78 & VDJ79 (does not suit 08/2016 on DPF models)
- Toyota Hilux – KUN, GGN
- Nissan Patrol – GQ / Y60, GU / Y61
Installation
- For installation, please download the Instructions from this webpage.
- For configuration, we strongly advise you to install the Dakota Digital App on your mobile device via Google Play or the Apple Store, as this is the easiest method for programming the unit.
Notes
- Not suitable for vehicles with speedos operated via CAN bus system
- eg Toyota LandCruiser 200 series & LandCruiser 70 series 08/2016 on
Customers reviews
Only logged in customers who have purchased this product may leave a review.
There are no reviews yet.